Hello everyone, I’m currently working on the design of a FortiSIEM
deployment expected to handle 10,000 EPS, and I’d like to get some
insights or recommendations from the community. Planned architecture1
Supervisor1 WorkerCollectors at each site (mul...
Dear FTNT community, Is there any way of configuring multiple
(different) isolation ports in FortiNAC-F 7.2.X ? In our case we want
one portal for wired connections and another different one for wireless
connections. Thank you in advance.
Dear @kendafulp , To review EOS information , please refer to the
following knowledge base article:
https://community.fortinet.com/t5/Customer-Service/Customer-Service-Tip-Product-Life-Cycle-Information-on-Fortinet/ta-p/194438
Note: If a product is n...
Dear AEK, I now fully understand your requirement. However, I do not see
any alternative 'cleaner' method other than the one you mentioned (URL
rewriting). a lot of other methods require changes on client side or on
the backend which i think isn't pr...
Dear @AEK ,I think using Content Routing with HTTP URL as the matching
criteria instead of the HTTP Host :App1 : you link its CR with server
pool for app1, then you specify the matching criteria : URL , then enter
/app1 (if match prefix) , or app1 if...
Dear @SteveJW ,You can use the automatic upgrade method for patch level
updates, since you're going from 7.4.4 to 7.4.5. Manual upgrade is
preferred when going through multiple patches / versions to avoid any
problems. Best regards.
Dear @samata ,As far as i know , There is no documented way to inject a
PSK via GPO/registry because FortiClient expects it from the profile
source (EMS (if deployed) or local config).So you can either go for EMS
deployment or configure it locally (m...
