Hello Fortinet Community, I have an SD-WAN deployment where a branch
site establishes two IPsec tunnels to the head office. The SD-WAN rule
at the branch is configured so that traffic destined for the head office
uses Tunnel 1 by default, and Tunnel ...
Hello Fortinet Community, I'm encountering an issue with application
control on my FortiGate 60F running firmware version 7.4.8M.Scenario:I
created a WAN access policy that allows NTP, DNS, and PING services
only. Additionally, in the Application Con...
Hi Fortinet Community, I'm currently using FortiClient EMS 7.4 and
FortiGate running FortiOS 7.4. When I try to access a server located in
the DMZ using ZTNA access policies with ZTNA tags, I receive the
following error: Despite this, everything seem...
Hi Fortinet Community, We're facing an issue where traffic shaping on
our FortiGate device doesn't seem to be working as expected. Despite
setting up the necessary configurations, no traffic appears to be shaped
— the system always shows current-band...
Hi AEK, Thanks for the reply. Yes, when either IPSec1 or IPSec2 goes
down at the branch, the printer and the printer management server can
communicate via the remaining tunnel without any issue.The problem
occurs when both IPSec1 and IPSec2 are up. W...
Hi @atakannatak , I have identified the issue. I had previously
installed a custom EMS CA certificate (ZTNA). After removing it and
reverting to the default certificate, ZTNA access started working as
expected. Best regards.Sadhi
Hi Fortinet Community,Just wanted to provide an update and share the
solution that worked for us, in case anyone else encounters a similar
issue.Thanks to Fortinet TAC support, we were able to resolve the issue.
Below is the complete configuration th...
