Hi @Zenhusen , So, you should connect via the console port and check the
management IP directly from there.Check if the https is configured under
allowaccess as below. Example FD-XXX # show system interface port1
config system interface edit "port1" ...
Hi @ik9 Thanks for your info. "it sometimes allows me to create a
loopback interface and a tunnel-interface with the same name in a single
step" Could you share a bit more about when it happens?Like: Which
FortiGate model and FortiOS version you’re u...
Hi Mandalorian, I double-checked on my side, and it’s working fine for
me.From your screenshot, it looks like WAN2 is running in full-duplex
mode — could you verify the duplex setting on the opposite end as
well?Below are the exact steps I used for m...
The default management IP address is 192.168.1.99, but this value often
changes once the firewall has been configured.To locate the current
address from the LAN side, try identifying the device that serves as the
default gateway—this is commonly the ...
