Dear community, I having troubles deploying a FortiADC in vmware
environment. Some interfaces are not working at the start, and sometimes
stop working sometime later. If I check the interface status in CLI with
command "diagnose hardware get devicein...
We’ve finally found the solution.. As mentioned earlier in this thread,
the issue was with the MAC address not being updated on the L2 switches
after a vMotion. The root cause was a misconfiguration in the port group
failover uplinks in VMware. After...
Hi all again and thanks to all that take the time to reply before :)
Adding some information to this issue, seems that the problem happens
when the vmware perform a vmotion of the VM. Any suggestion about this?
Thanks a lot.
Checking in documentation I see that we need the "mac address changes"
and "forged transmits" and I already have enabled. I think that the
promiscuous mode is not needed, is a requirement for fortigate not for
fortiadc. Do you think that I need to en...
Thanks again AEK. Both Forti and VMware logs has been checked and did
not appears something related to network problems. Notice that this
problem is not only happening in one interface, it happens in differents
interfaces from both forti servers but ...