Hi everyone I have two firewalls 201G model version 7.4.6, when i
configure vdom partitioning with separate two cluster root and rnd. Root
is primary in cluster 1 and rnd is primary in cluster 2, but rnd didn't
work. I show HA configured, which is no...
Hi everyoneI have a problem when pushing configuration from Fortimanager
to Fortinet firewallI used Fortimanager version v7.2.5-build1574 with
evaluation license and pushed the sd-wan overlay template and it noticed
the error but I do not see the err...
Thanks, I use group ID 100 for HA. When I tested yesterday, I didn't see
"PADO" response, although I connected both ports on the primary and
secondary. I think it has a problem when rnd primary on pppoe process
due to wrong forward pppoe packets. Ins...
I also tried yesterday. When I connect with the solution you said above,
the port status is up, but pppoe status is "installing" forever.
However, if I assign a static IP via an internet leased line, it works
well. Do you think the cause is fortigate...
Thanks for your suggestion, but I wonder why I follow the guide and the
status shows correctly. Where was I wrong in this case? And what do I
need to check, because the solution " I moved two VDOMs to make them
active on the primary firewall. It's wo...
Yes, I also follow that document when I configure, but the vdom in
cluster 2 does not work, and the port status is down as I said above.
Now, I moved two VDOMs to make them active on the primary firewall. It's
working normally.
I have reconfigured the phase2-interface proposal and it resolved
Because Fortigate with an evaluation license does not support the
proposal created by Fortimanager. I have changed it and the pushing
configuration is done.Thank you very much!
