Did somebody ever tried to use a encrypted PSK from a v3 with a v4 while
the Firmware wasn' t upgraded on the same firewall (copy&paste from the
v3 config file to a new v4 FGT)? Does it work or do I have to retype it
in the v4 GUI/CLI? regards, Patri...
I' ve just installed the FAP220A with a FGT80C (latest Firmware MR2
Patch 3 - build 0303). The first time everything worked fine in the lab.
I' ve upgraded the Firmware of the FAP and everything worked. After I'
ve unplugged the power the FAP didn' t...
Hello, I' ve got a problem between a FGT60B (running v4 MR2 P2) and a
Cisco 3825 v12.41A. The VPN ist established. The network behind the
Cisco should reach a Webserver behind the FGT. ICMP works fine in both
directions. But the network behind the Ci...
Hello, is it possible to set a VPN Tunnel via CLI " Up" / " Down" (like
via the Webintterface/Monitor)? I' ve searched in the CLI Reference, but
found nothing :( Best regards, Patrick
Hi Dan, you have to enable it for every protocol you'd like to scan.
Otherwise in proxy mode no av+webfiltering will work. By default it
should be enabled. I had also one unit/firmware there it was disabled by
default. Cheers, Patrick
Are you using Proxy or flow mode? Did you checked the following
Settings?: config firewall profile-protocol-options config http set
Status enable # <- this must be enabled ; otherwise webfiltering AND AV
won't workendnextend