I've cross checked the knowledge base multiple ways on this issue, and
I'm can't tell if this is a setting or a firmware issue or just hard
coded. Firmware is 7.2.11 on a Fortigate 80e I use the CLI console from
the GUI often. Mainly I use it to SSH ...
Fortigate 7.2.9Forticlient 7.2.4.0972Forticlient EMS 7.2.4.983 I've
gotten this to work using just the internal IP address over ZTNA for
connecting to an RDP server. I followed the steps to configure ZTNA for
use with FQDN (ZTNA TCP forwarding access...
We are in the process of doing a basic Forticlient EMS setup. I've been
going through all documentation and searching for answers to the last
part of the puzzle. Our setup: Forticlient EMS on Windows ServerFabric
is configured on FortiGate and syncin...
No its not. I sat at the command prompt without connecting to anything.
And 50 seconds later, it kicked me out. Edit: I further tested by
entering commands for 1 minute then stopped. And at 1:50 I was kicked
off. So I confirmed its a 50 second idle t...
