Dear Experts , I have two sites connected , FGT-60C and FGT-90D via
IPSEC. I have a strage issue with some hosts on my network . host A
(10.10.110.169, FGT-60C) pings host B over IPSEC (FGT-90D) and I get
response when I'm trying to do the same and p...
Hello Experts , I have a FGT90D on Site A (only WAN1)and a Fortigate 60D
on Site B (WAN1 , WAN2) When I setup a IPSEC between Site A(90D) to Site
B (60D) everything works fine on WAN1 to WAN1 but when setup a tunnel on
WAN2 interface SiteB -60D to Si...
Hello I'm running site to site vpn with 2 fgt. 90d -> 60c we're
occasionally experiencing bad line quality .from reading online I
understand that the IPSEC has different configurations affecting the
overhead used due to encryption etc etc. Is there a...
*host 10.10.110.169 has gw defined properly 10.10.110.1 FGT 60D local
address. *host 10.10.110.169 can ping LAB B. I can ping successfully
locally from FGT 60D:first code section on my original post was the ping
from the fw.here is the sniff : diagno...
Hi , Thank you for your fast reply. 1. what is plos ? I'll try to use
tcpdump + callstats to figure out the jitter and capture some rtp
streams. 3. usually the problem is one way e.g. 90d expriences bad call
quality but the 60c hears fine. maybe 60c ...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites