Hello everyone, I'm trying to figure out how I can allow one of my
Fortinet inferface to be able to ping the "IPsec VPN" IP of my remote
users (connected with Forticlient). From the Fortinet itself, I'm able
to ping those IPsec VPN connected workstat...
Hello everyone, I just wanted to update this forum with the solution to
my original issue.(I had to open a case with support, to get this
resolved) Turns out that all my routes and IPv4 Policies were setup just
fine.My issue was caused by the "net-de...
If anyone has any experience in allowing internal traffic (internal
interface) to an IPsec VPN tunnel (Forticlient connected devices),
please let me know. Thank you.--Eric
Hello Ede, Thank you so much for your response about my current issue! I
was assuming that a static route was not required, thanks for clearing
that one out. I already have a policy that has been created for trying
to get the ICMPv4 to get through:- ...
I'm actually not only trying to allow "ping" from a device
(workstation/server) within my organization to the "Ipsec VPN connected
devices (with forticlient)", but I would like to allow other kinds of
traffic as well (i.e. being able to access the lo...
