Hi, We're migrating to a new network structure but need to keep the old
network for a couple more weeks. I have the following setup: * port2 -
192.168.0.1/24 - physical interface* port3 - 10.55.0.1/24 - physical
interface I need to create a tagged VL...
Hello, I'm running into problems setting up a secondary WAN to be added
into the LLB. Specifically the NAT Policy. Our ISP provided us a media
convert but no L3 router to our office. They gave us a /30 address block
for the provider edge (PE) and cus...
I'm setting up a new office that will have a little under 200 users. I'm
not sure which product to use. I'm thinking of getting either 2 units of
the 100D set up in HA mode, or a single 200D. With the 100D, I can setup
a full mesh with a set of stack...
I did check that it works. From my understanding, I can have a router
device between the media converter and the FortiGate that routes the /30
to the block that they gave me, and I can assign the the CE address to
one port (10.188.30.142), and one of...
Hi Ralph, Yes, I did consider that. What I'm planning to do is to make
use of a 60D in the cabinet, and use that as a "manual" backup in the
worst case that the 200D fails. We have a technical services department
that should be able to handle the phy...
