Re: Route traffic using Fortiswitch, but witouth I...

jroy777 · 09-20-2024

So I have some questions about BGP community-listsIs a route-map required to use with a BGP community-list? I have a single Data Center with two 10G AWS Direct Connect Circuits and the subnets on both ends are exactly the same, just a redundant path....

jroy777 · 09-16-2024

We have existing Fortiswitch that is connected to a Cisco ASR. The Cisco has the layer 3 interfaces and IP's assigned for WAN and vlan subnets. We want to now install a second FortiSwitch, use the layer3 capabilities and use vrrp to make the link red...

jroy777 · 04-30-2024

We have a working Cisco router doing bgp to AWS Direct Connect. What is the correct way to create the layer 3 interfaces (Direct-Connect, inside and dmz/uat) and the required Vlan 2900 with correct dot1Q encapsulation. Do I create on a sub interface ...

jroy777 · 04-29-2024

I want to assign an IP on the internal (btw, what does that mean?) that is in the same subnet as the management IP.Mgt 192.168.50.40 internal 192.168.50.41It keeps telling me there is overlap. So I found this, and applied but it does not work. Even t...

jroy777 · 09-23-2024

Thanks for the replies!OK, A couple of questions. 1) I already have BGP setup on the Primary Link and subnets are being passed and traffic is flowing. Why would I need a route map?2) Does my secondary FortiSwitch need to become a BGP neighbor with th...

jroy777 · 09-20-2024

I have advanced license applied. The BGP is working on the Fortiswitch and I will revisit MCLAG at a later date. I would love to see your settings/configs when you get it completed :)

jroy777 · 09-19-2024

Did you finally get this working? I have two Fortiswitches and the L3 Routing portion working with BGP back to Amazon AWS, But I am confused on the mclag portion. I have been unable to get any IP traffic from a host on any of the vlan's to cross the ...

jroy777 · 09-17-2024

Thanks for the response. I have an issue at the moment that won't even let me get to the vrrp portion. I am unable to establish the layer 3 BGP connectivity on the FortiSwitch back to AWS. I had this same issue with the 1st FS and ended up installing...

jroy777 · 09-16-2024

Would I use this? https://docs.fortinet.com/document/fortigate/7.4.0/new-features/369021/support-inter-vlan-routing-by-managed-fortiswitch-units-7-4-1#Configur3or This?https://docs.fortinet.com/document/fortiswitch/7.4.3/fortiswitchos-administration-...

User Statistics

User Activity

Is a route-map required to use with a BGP community-list?

Can we do VRRP/BGP and redundant wan paths? Can it be active/active or only active/passive?

Duplicate a working Cisco Router config on a FortiSwitch 424E-Fiber

Management and internal

Re: Is a route-map required to use with a BGP community-list?