Hi, I checking on my FortiAnalyzer, seem the resource for the CPU really
high. I monitored it almost 1 day and restart some of the service but
still same. Based on the exe top output, some application that utilized
most of the cpu are siemagentd & po...
Hi All, I got deny log from the Fortigate even I already configure to
allow the connection.This application using port 1433. The details log
as below : Event Action : DenyThreat Action : BlockThreat Name : Policy
ViolationThreat Type : Reconnaissance...
Hi, We having an issues where the SSH keep timeout when idle. This
happen only for 1 IP Segment / VLAN. Not sure if this related to the FW
since we have multiple switch in between. User -> Floor Switch -> CS
Switch -> FW -> Servers When login and idl...
Hi, I noticed i unable to access the FortiSandbox at my office.
Previously it working fine and the hardware is up and running. The
network port is blinking, but the LED status no light & HDD status
blinking red. I already restart the hardware but sti...
TQ for the KB, based on the license we dont have the SOAR & SIEM bundle
service. So we just can disable this features cause as per checked it is
running, but it required downtime so will do it during the maintenance
time. Also i noticed the CPU was h...
Hi, Thanks for the reply. The traffic direction is inbound and this is
new configuration. After some checking I notice the previous service
port have Source Port destination configured with value 0. I believe
that was the cause why the traffic was dr...
Hi thanks for the suggestion, based on the packet capture (wireshark), i
cant find which device (server / client) sending the FIN packet. For
this scenario i run the packet capture on client laptop. After 5 - 10s
the session close. We have other serv...
Hi just want to update, i restarted the Appliance (no red blinking) &
change some setting on the switch connected to the appliance & now it
reachable from the network. i run all the disk command and the HDD is
healthy.
