I am trying to setup a new site with a new Fortigate at it and put an
IPsec tunnel between it and the parent site. I have done this before but
am having what I think are routing issues. Site 1 - Firewall 1 (300E
cluster running 6.2.4) IP Range - 10.2...
I have a FortiWiFi 60E that I am using (running 6.4.x) and found WiFi
performance to be poor. My WAN connection is capable of 500M and WiFi is
barely 100M. If I use the built in WiFi on the ISP supplied router then
this reaches the full 500M easily, ...
FortiOS 6.0.9 on a cluster of 300Es. SSL VPN configured and being used
by staff working remotely. Everything works great. Users have
FortiClient installed and we have EMS server managing that side of
things as well. We have some internet-based applic...
Is it possible to packet sniff within an SSL VPN tunnel? We have
creatred an SSL VPN for staff to connect back into the estate, which
works fine, but some rules are not working as expected and some traffic
is being blocked. With non-VPN traffic, I ca...
I could have sworn that I had done this before and not had to have the
interface up, but it was a while ago and I could be remembering
incorrectly. Remote FW routing shows:S 10.200.0.0/24 [254/0] is a
summary, Null Local FW shows:S 10.200.1.0/24 [254...
I just used the "policy lookup" and "route lookup" in the GUI. Simple,
but usually matches a route/policy if things work even when the
interfaces are down. Doesn't test but does tell me if there is a route
or policy out, and in this case it matches t...
I have tried all sorts of combinations. What you see there is what got
the best speed. Other options I was barely getting above 1M on some and
10-20M on others.
Yes, cabled in is working much better so this seems to be just a WiFi
issue. Attached screenshot for 5GHz as I can't attach more than one for
some reason. But this is the one I am normally using.
