I'm currently trying to troubleshoot the VPN tunnel why it won't work
and what is missing for it to work. Problem is, I can't reach or have
any connection to the dialup peer for the VPN. I only have a backup of
the config so I can try to imitate the ...
I have noticed if you set an IP-Range for the client configuration. It
will then give the client the first IP-Address that is useable, and then
set the Gateway to the second IP-Address of the range. Can you set the
gateway manually?
Is there an Option in the FortiClient Endpoint Management Server to
allow users to change the Log Level on their own? I have seen a post
about the same issue but the answer didn't help. Even after changeing
the System Settings of the Profiles. It was...
On CLI, when a user tries to assigne the option ‘peer id from dialup
group’ in the dial-up IPsec tunnel: # config vpn ipsec
phase1-interface(phase1-interface) # edit (phase1 name) #
set peertype dialup(phase1 name) #set usrgrp Error:
auth_user not a ...
Hi Tahsin, so FortiClients that are managed with EMS can't change their
Log Level on their own then? When we want to for example debug the
FortiClient on one device, we would have to put it into a new Policy
with the different log level.
Thank you for the Answer. I looked up the EAP authentication and found
the article, 191040 that talks about a way to utilize RADIUS. I'm going
to try it out and see if it works.
