Does someone know which ports are used for vpn ipsec tunnel under sdwan
scenario considering this fortigate is behind a NAT ISP connection?
apart from UDP 4500 and 500 ports which one are require to allow it.
My current 100F firewall is configured with 400 sdwan spoke members and
each member with a health check SLA, but when health-check set interval
is set to 1500 ms it affect my CPU process and reach 100% is there any
range or limit suggested to avoid C...
current F 90D version is 6.0.9 build0335, this FW works as UTM, wan
primary ip is private and secondary ip is the public routed throughout
the private ip to reach internet, all filters to current public ip (set
as secondary) are enabled to allow only...
Following issue shows a wrong connection to Fortiguard-log server,
password is correct and worked properly with another Fortigate device,
diagnose log is activate but I can't connect to Forticloud: FORTI-40F #
execute fortiguard-log login xxxMAILxxx ...
Community Following issue showed a wrong connection to Fortiguard-log
server, password is correct and worked properly with another Fortigate
device, diagnose log is activate: FORTI-40F # execute fortiguard-log
login xxxMAILxxx xxxPWDxxx2024-03-13 12:...
Thanks a lot, but, just a doubt, how is considered the priority between
local-in policy and management interface trusted hosts? if the ip is
blocked through local-in policy but allowed inside trusted host ?
Really preciated, I need to allow only some icmp source, i.e. my monitor
network, and closed to everyone else, I cant identify which rule is the
proper one to block
