Hi Team, I have several Fortiswitches managed via Fortilink, and I need
to configure snmpv3 with one Read and one Read/Write user. This
configuration must be done from Fortigate? Can you provide me the steps
to follow to perform this configuration. T...
Hi Team, I need to know if it is possible to change the MTU on the ports
of a Fortiswitch, I have been reviewing the config, and the only thing
it allows me to change, is the MTU in: HOSTNAME # conf system
interfaceHOSTNAME (interface) # edit interna...
Hi Team, I have configured a FortiSwitch 108F-FPOE // version
S108FF-v7.2.4-build5148,230530 (GA) // via fortilink and everything
works ok, but when I reboot the Fortiswitch, I start getting messages
saying "FortiLink: ISL timing-out for trunk". Info...
Hi Team, I need help to know how to perform the configuration on the
different network elements for the Fortigate to discover the
Fortiswitches on Vlan1001. Is it possible? The scenario is as follows:
Thanks & Best Regards,Juanmi
Hi Team, I need to automate the execution of configuration backups
automatically, and I have encountered the following problem:
FortiGate-600F v7.0.12,build0523,230606 (GA.M) with 2 Vdoms If I launch
the command:execute backup full-config sftp Config...
Hi tpatel, No, I don't have mclag-icl configured in the Fortiswitch, I
have this configuration: Fortiswitch Trunk configuration config switch
trunkedit "_FLinkDhcpDisc_"set auto-isl 1set static-isl enableset
members "port10"nextend Thanks & Best Rega...
Hi @ozkanaltas, One doubt, if we change the Vlan 4094 in FortiGate for
vlan 4084, I understand that it will be necessary to make the change in
the FortiSwitch as follows: config switch auto-networkset mgmt-vlan
4084set status enableend config switch ...
Ho Team, I have tested on three FW with different versions and on one it
works and on the other two it does not. Below I summarize the tests
performed in each case. FW1 version v7.0.12 build0523 (Mature) Exucute
Backup from vdom Global# Execute backu...
