Help
Fortinet Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.

Forum Posts

Start a conversation

All Interface Dead

Hi All i have 100D and work normally, but after i downgrade from 6.0 to 5.2, i found all the port not work but i can access CLI and check hardware dialogic without any error, have any idea what problem? cannot ping, access, i confirm allow ping and a...

VPN Tunnel fail when removing SLAVE from HA

Hi All, I have experienced and issue that I was not prepared to encounter. Here is the scenario: 1000D in HA running 5.2.4Multiple IPSEC tunnels with OSPF running inside Upgrade reasoning:In order to upgrade to 6.0.5, wanted to take the slave out, up...

Question: WPA2 Enterprise Wi-Fi authenticate via local user

Hello,When I follow this guide to setup a WPA2 Enterprise Wi-Fi (TAIMO-ELOGY) authenticate via local user. The error shows when I connected with any device. There are no log in Wi-Fi Connection and User authentication related to this issue. Create a ...

Peter_Liu by • New Contributor
  • 1104 Views
  • 0 Replies
  • 0 Likes

LDAP authentification on HA-Cluster fails

Hi Guys, i configured LDAP on all our Firewall and it works prefect! We're using 3040B Fortis with Firmware v5.2.13,build762.The Cluster is Active-Passive. config system ha set group-name "fw-CUST" set mode a-p set password ENC set hbdev "wan1" 50 "w...

dudarra by • New Contributor
  • 2585 Views
  • 2 Replies
  • 0 Likes

5.2 dual wan policy routing with priority, possible?

Hey everybody, Im running into more and more sites where I am having a need for policy routes, but still maintain the ability for failover for multiple WANs. The bulk of my sites are 60Ds, 200Bs, 300Cs (few hundred sites). Half are independent, half ...

Demoh by • New Contributor
  • 1095 Views
  • 0 Replies
  • 0 Likes

Contact Us