Hello,
I am trying to setup "WAN Link Load Balancing Interface" in my firwall(see below for details), I couldn't select wan1 or wan2 on the load balance setup screen. Any idea what could be the reason?
Device: FortiGate 60D
Firmware Version: v5.2.2,build642 (GA)
Please see the attached screenshot.
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
For WLLB, you should remove the wan interfaces wherever they are currently using. Like address, VIP, policies, routes, vpn etc.
after that you can use the WLLB.
It is better to have firmware version 5.4 for WLLB. It works good on this firmware.
Anurag Goyal
Thank you Anurag. Can you suggest the exact firmware version number like 5.4.x?
just start with 5.4.0 only.
Anurag Goyal
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1696 | |
1092 | |
752 | |
446 | |
228 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.