vpn tunnel must always up

[Fullmoon]

already established my ipsec vpn using dialup setup, my HQ was configured using public address and remotes sites using dynamic/public /private ip addresses. However the tunnel would only established if there was a traffic initiated from remote sites. What I want is the tunnel must be up all the time no matter no traffic coming from remotes sites HQ Phase1 Settings Keepalive frequency 10 (default) dead peer detection enabled Phase 2 Autokey Keep Alive enabled Remote Phase1 Settings Keepalive frequency 10 (default) dead peer detection enabled Phase 2 Autokey Keep Alive enabled Any inputs are highly appreciated :)

[ede_pfau]

Set this option in the CLI on the remote side FGT:

 config vpn ipsec phase2-interface
     edit " my_phase2" 
         set auto-negotiate enable
     next
 end
 

[Carl_Wallmark]

As of 5.0.3, the auto-negotiate is in the GUI ;) (my request )

[ede_pfau]

Cool! Please request 5.1 asap...

[Fullmoon]

thanks for the info guys :)