Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
You should port FGT config instead of Juniper's at this forum. If you want to ask about Juniper config you should go to their communities at "Elevate" https://community.juniper.net/home
First, FGT doesn't have concept of "native vlan" because it's NOT a L2 switch or L2/L3 switch-router. So the untagged VLAN 200 on the Juniper side connects to the physical/parent/non-tagged interface on the FGT. You need to configure L3 for this at the parent, say 'port 1' interface. Then all the other VLAN subinterfaces under the parent 'port 1' interface. You obviously need to create a set of policies to allow access between specific combinations of VLANs.
OP so the juniper cfg looks okay
Q1: is the fgt going to be native vlan-id 200? If yes just configured the physical port as-is and assign the /30
Afterwards check the juniper EX
# example using ge-0/0/0
show vlan 200
show interface ge-0/0/1 brief
show ethernet table interface ge-0/0/1
Ken Felix
PCNSE
NSE
StrongSwan
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1561 | |
1034 | |
749 | |
443 | |
210 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.