set internel-switch mode interface

[Marco_Broker]

Hi ,

      Can someone help me . I have an issue to break a fortigate  60D  version 5.2 into interfaces mode . I have disable the DCHP on the lan and deleted all policies related with the internel lan . Using the following command on cli .

config system interface

set internel-switch mode interface

end

the ports still remain the same into switch mode .

Please can someone help me .

[Toshi_Esumi]

Did you get any error message when you typed the commands? It should complain you if your forgot to remove any references.

It's been quite some some since interface mode has become the default. But if I remember correctly, with the default config of older 5.2.x, you need to remove the default policy, and remove dhcp server and interface IP from lan interface, then remove the default dhcp server config referring lan interface. Then change the mode and reboot.

[journeyman]

Having deleted references to the internal interface I believe you need to delete the virtual switch. Our process used to get a new unit ready to join a cluster is as follows, you may not need to change the wan port modes:

config firewall policy

    delete 1

end

config system dhcp server

    delete 1

end

config system virtual-switch

    delete internal

end

config system global

    set switch-controller disable

end

config system interface

    edit wan1

        set mode static

    next

    edit wan2

        set mode static

    next

end

[Marco_Broker]

Hi Journeyman  ,

                            Thanks for reply man . I have found a solution I have backup the configuration file and open in a notepad modify the internal ports and reload it . it has been break .

Thanks for support man .

[kkriss81]

Hi i have Fortiwifi 60E

Firmware 6.0.0

I don't have this command. But i need use each port.

xxxxxx (global) # set internal-switch-mode interface

command parse error before 'internal-switch-mode' Command fail. Return code -61

[sw2090]

I stopped using the clil command in FortiOS 5.4 because I noticed that in 5.4. or higher you can simply delete the virtual swich to get back to single interfaces...

[mahesh_secure]

Hi 


config system global

set internal-switch-mode interface 
end

Try this 


Mahesh

[mahesh_secure]

hi config system global set internal-switch-mode interface end Try this Mahesh