"diagnose netlink interface list port" CLi command

[yamidt_FTNT]

Hi team; on a subinterface We set inbound and outbound bandwith limits:

config system interface edit "port2.212" set vdom "SURI-Ext" set ip 64.178.212.237 255.255.255.0 set vlanforward enable set inbandwidth 25600 set outbandwidth 25600 set snmp-index 200 set interface "port2" set vlanid 212 next end

We ran "diagnose netlink interface list port" and got:

if=port2.212 family=00 type=1 index=227 mtu=1500 link=0 master=0 ref=382 state=start present fw_flags=0 flags=up broadcast run promsic allmulti multicast Qdisc=noqueue hw_addr=00:09:0f:09:fe:0d broadcast_addr=ff:ff:ff:ff:ff:ff inbandwidth=3125 outbandwidth=3125(0:963 0:0 0:0 2:0 3122:0)  <------- stat: rxp=232845992 txp=322882953 rxb=56184968152 txb=344946388806 rxe=0 txe=0 rxd=0 txd=0 mc=0 collision=0 re: rxl=0 rxo=0 rxc=0 rxf=0 rxfi=0 rxm=0 te: txa=0 txc=0 txfi=0 txh=0 txw=0 misc rxc=0 txc=0 stop=0 input_type=0 state=6 arp_entry=3 refcnt=382 Do you know hat means the following line?

inbandwidth=3125 outbandwidth=3125(0:963 0:0 0:0 2:0 3122:0) <-------

I have searched on mantis but I did not find any about it.

Kind regards,

Yamidt Henao Technical Account Manager  

[align=center]

---

[/align]

E: yhenao@fortinet.com T: 408.486.7834 M: +52 1 5551034829

412 Paseo de la Reforma | Ciudad de Mexico, MX 94086

[align=center]

---

[/align]

[ede_pfau]

hi,

the 'inbandwidth' parameter is given in kilobits per second (kbps) whereas the diag command output shows kilobytes per second (kBps).

This being said, the diag figure should really be '3200' (= 25600 / 8) and not '3125', or the config option should be '25000' instead of '25600'. Are you sure both are taken at the same time?

FortiOS version?