- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ping with source IP interface on Fortigate device
Hello Dears
I want to make source ping from fortigate firewall device towards internet since by default it is blocked take in mind i am not using VODM anyone can help
Bests
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
By default it should be allowed, do you have a route ? Can you share the route, interface IP and error you are getting?
Suraj
- Have you found a solution? Then give your helper a "Kudos" and mark the solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Dear
thnx for reply
yes default route , NAT configred but no lack to reach internet as show on attached
the IP address is set to port6 as secondary ip address
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @MustphaBassim ,
Thank you for contacting the Fortinet Forum portal.
-You are using correct method on other window can you run below sniffer to see if you are getting reply back ?
diagnose sniffer packet any "host 10.150.39.241 and host 8.8.8.8" 4 0 l
ctrl+c to stop sniffer
-If it is ISP secondary check if the arp entry for secondary wan gateway IP is there on FortiGate by command
get system arp
articles for ping-options:
Best regards,
Manasa.
If you feel the above steps helped to resolve the issue mark the reply as solved so that other customers can get it easily while searching on similar scenarios.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @MustphaBassim,
You can use a sniffer on another cli as shown below to verify the interface being used by FortiGate.
Dia sniffer packet any ' host 8.8.8.8 and icmp ' 4 0 l
Regards
Rajan