- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
networking monitoring using snmpv3
we are settinng up our own networking monitoring tools using Opmanager.
what is the proper way to configure snmpv3 for our fortigate firewall so that the Opmanager can recognize our firewalls ?
Solved! Go to Solution.
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @yeowkm99 ,
You can follow this guide to configure SNMPv3.
https://docs.fortinet.com/document/fortigate/7.4.4/administration-guide/325005/basic-configuration
NSE 4-5-6-7 OT Sec - ENT FW
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @yeowkm99 ,
You can follow this guide to configure SNMPv3.
https://docs.fortinet.com/document/fortigate/7.4.4/administration-guide/325005/basic-configuration
NSE 4-5-6-7 OT Sec - ENT FW
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @yeowkm99 ,
once configured if you are having issues, you can refer to this troubleshooting article for SNMPv3
https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-SNMPv3-debug-error-USM-decryption-er...
https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-troubleshoot-on-FortiGate-when-SNMP...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @yeowkm99,
What is your firmware version? I found this document on an older version but let me know what is your current one and I can attach a newer version document https://docs.fortinet.com/document/fortigate/6.2.16/cookbook/457149/snmp-v3-users
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
using ver 7.2.8
