Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
iperf3 and using x1 port
Hello all,
I'm trying to setup one of my FG's to use iperf3 and the FG I'm trying to use is using port x1 for the WAN connection but I can't pick this port using the command diagnose traffictest client-intf portx1
If I pick any other port it will select that port, but that doesn't help since my fiber is on x1. The port is setup as SD-WAN zone. Thanks
Labels:
- Labels:
-
FortiGate
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Could you please post the FortiGate model and firmware version used?
best regards,
Jin
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @Rsena
Did you try with "diagnose traffictest client-intf x1" instead of "diagnose traffictest client-intf portx1"?
