iperf3 and using x1 port

[Rsena]

Hello all, 

I'm trying to setup one of my FG's to use iperf3 and the FG I'm trying to use is using port x1 for the WAN connection but I can't pick this port using the command diagnose traffictest client-intf portx1

If I pick any other port it will select that port, but that doesn't help since my fiber is on x1. The port is setup as SD-WAN zone. Thanks

[jintrah_FTNT]

Hi,

Could you please post the FortiGate model and firmware version used? 

best regards,

Jin

[nweckel]

Hello @Rsena 

Did you try with "diagnose traffictest client-intf x1" instead of "diagnose traffictest client-intf portx1"?