in/out filter on BGP

[MustphaBassim]

Hello Dears

I am trying to add a route map on BGP out filter as below :

network 1 : 100.68.0.10/32

network 2 : 100.68.0.12/32

network 3 : 100.65.0.144/28

network 4 : 100.65.0.226/32

it's allowing only /32 networks but the /28 network is not announcing to neighbor take in mind all 4 networks are static route redistributed

and also I am trying to filter the out network to the neibhour but it is not working using route map and access-list

Bests

[jintrah_FTNT]

hi,

Could you please post the output of command,

#get router info routing-table details 100.65.0.144

best regards,

Jin

[MustphaBassim]

FortiGate-601E-1 # get router info routing-table details 100.65.0.144

Routing table for VRF=0
Routing entry for 100.65.0.144/28
Known via "static", distance 240, metric 0
vrf 0 100.64.0.2, via port3

Routing entry for 100.65.0.144/28
Known via "ospf", distance 110, metric 11, best
Last update 3d01h01m ago
* vrf 0 100.64.0.2, via port3

here it's dear

[funkylicious]

I would suggest this:

- use prefix-list to filter in/out prefixes from/to neighbors

- advertise under, config network > edit <> > set prefix <> , the directly connected prefixes and from other protocols just to be sure

- advertise under, config redistribute ospf , the 100.65.0.144/28 network.

[MustphaBassim]

Hello Dear 
the issue I the need to filter more than one network (in/out) so does route map is ok ? 

[Toshi_Esumi]

Are you saying the /28 is in the routing table but not in BGP table?
"get router info bgp network 10.65.0.144/28"

For filtering I would suggest matching those with a prefix-list then use it in in/out route-maps.

Toshi