i have FortiSwitch-124F-FPOE v7.4.0,build0767,230602 (GA) and i cant config netflow or sflow,
I just can configure these commands
config system sflow
set ip 172.16.220.20
is netflow or sflow needs licenses ???
Sflow or netflow don't need licenses, the configuration only shows the collector IP, you also need to speficify the port number and then enable sampling under the interfaces.
config switch interface
set packet-sampler "enabled | disabled"
set packet-sample-rate 'count'
set sample-direction 'rx | tx | both'
set sflow-counter-interval "interval''
- Have you found a solution? Then give your helper a "Kudos" and mark the solution.
Thank you ,
but i can found these commands under the port configuration
Below given is the config guide for 7.4https://docs.fortinet.com/document/fortiswitch/7.4.0/fortiswitchos-administration-guide/741913/sflow
sFlow is not supported by 124E. Has to be either 124F or 148E for the 100 Series.https://fortinetweb.s3.amazonaws.com/docs.fortinet.com/v2/attachments/04cb1b8c-009d-11ee-8e6d-fa163e...Toshi
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2023 Fortinet, Inc. All Rights Reserved.