how to Check the zombie process in FG90D

[herekim]

Now I have a problem with my FGT90D。It Cannot login from an HTTPS but ssh， and when press "diagnose sys top 9 99" or "diagnose sys top-summary" ，cannot see httpsd and other zombie process .

So I wonder what cli command should I use that could see all the zombie process? or the whole processes? 

thanks！

diagnose sys top

[Toshi_Esumi]

If you don't see it at all (see below), the problem is not zombies but the fact it's not running. I don't know what could cause it but I would reboot the unit as the first step of troubleshooting process.

xxx-fg1 # diag sys top-summary | grep httpsd    129      32M    0.0  1.8    22  01:44.50  httpsd [x4]    129      32M    0.0  1.8    22  01:44.50  httpsd [x4]    129      32M    0.0  1.8    22  01:44.50  httpsd [x4]    129      32M    0.0  1.8    22  01:44.50  httpsd [x4]

[emnoc]

Can you  disable the  HTTP allow access and re-enable and then check ? I seen this same issue where HTTPS was not working but it was by and only on one interface.

I also recall you have "diag sys tcp" or similar command to look for local netsockets that you can run. maybe some one will chime in on that command and syntax. But do you have a listener?

Also , ensure that your trustallow is not blocking you but if your getting thru on ssh, than most likely  that is not the issues. 

lastly, enable "http" and then test to ensure it's NOT a https vrs http and possible certificate issue ( and you should test with a different host and browser if that has not been done )

Ken