ha display bug?

esfgten · ‎05-07-2023

I am using OS 7.0.10 for FGT-1101E.
When A-P mode HA is set, both devices are displayed as Primary on the top of the GUI.
The command get sys ha status shows primary and secondary normally.
Even if you test with the FGT-401E device, both devices are displayed as Primary.

Has anyone found this symptom or solved it?

srajeswaran · ‎05-07-2023

Do you have virtual cluster enabled? I remember seeing similar issue reported for virtual clusters.

Also, is it possible for you to test the behavior in 7.0.11, I have tested 7.0.11 cluster and didn't see this issue.

Regards,

Suraj

- Have you found a solution? Then give your helper a "Kudos" and mark the solution.

esfgten · ‎05-07-2023

hi team,

Yes, Vdom is enabled. (global, root, mgmt, service)

I've tested 7.0.11, but the same problem occurs.

srajeswaran · ‎05-08-2023

As per 7.2.4 releases notes this issue is fixed.

843837

HA A-P virtual cluster information is not correctly presented in the GUI and CLI.

https://docs.fortinet.com/document/fortigate/7.2.4/fortios-release-notes/289806/resolved-issues

Regards,

Suraj

- Have you found a solution? Then give your helper a "Kudos" and mark the solution.