Hello,
I'v got a fortigate 100D which is unable to assign a IP for management in the same vlan as the LAN.
its a single 100D ( no HA ) which I want to manage from vlan 10, the same subnet as the current management IP on LAN side.
the gui is slow, probably due to production traffic going over the same port.
hence I want to mitigate the management port to where it is supposed to be.
however altho I'v enabled subnet overlap, which solves the issue shown below
I still can't get it to work, when I press ok the 100D comes with item not found ;
your assist or opinion is very welcome, thanks in advance!
Solved! Go to Solution.
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
This has been broken since 5.4, it worked on version 5.2. I have multiple HA clusters, with individual IP addresses for management only in the same interface subnet VIP. It worked but they broke it in 5.4, I opened a support case on 09/02/2016 and they list it as a "bug". Checking on the status a few weeks ago, they say it "may" be fixed in release 5.6 but not sure. WHAT? Why am I paying for support?
But you can set it by CLI, that worked for me.
I'm sorry I see the pictutes didn't come along in the post.
on the first picture there is an error notification due to overlap. I'v resolved that in the CLI with
config system settings
set allow-subnet-overlap enable
then when entering the IP that is in the range of the LAN network I get the well known error ; item not found
This has been broken since 5.4, it worked on version 5.2. I have multiple HA clusters, with individual IP addresses for management only in the same interface subnet VIP. It worked but they broke it in 5.4, I opened a support case on 09/02/2016 and they list it as a "bug". Checking on the status a few weeks ago, they say it "may" be fixed in release 5.6 but not sure. WHAT? Why am I paying for support?
But you can set it by CLI, that worked for me.
thanks joepope! I was already wondering if it was just me or a bug, will get into the CLI config of the interface later. cheers!
the CLI configuration of the mgmt interface in the CLI works like a charm!
a small tip when running into issues like this is reading the release notes!
this specific bug is noted in all 5.4 releases
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1705 | |
1093 | |
752 | |
446 | |
230 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.