enabling ospf on fortigate

[sims]

Hi,

interface fa0/2 

ip address 192.168.2.10 255.255.255.0 

1 ) router ospf 1 

network 192.168.2.0 0.0.0.255 area 0 

2 )  interface FastEthernet 0/2

ip ospf 1 area 0 

If I want to do the same setup on fortigate  do I need to specify both interface and the network ?.

In gui I can see both 

If Yes why we have to do this . Usually on cisco we  either we use under interface(2)  or network (1)

Thanks

[emnoc]

The ospf.cfg is simple

config router ospf

set router-id x.x.x.x

config area

edit 0.0.0.0

 next

end

config network

edit 1

 set prefix 192.168.2.0/255.255.255.0

 next

end

config ospf-interface

 edit "internal

 set interface "port1"

 set priority 200

 next

 end

end

Do all interface specific under the interface, concept is  very simple  and straightforward

[sims]

Hi,

My question is the below commands are not enough to broadcast a network using ospf 

config router ospf set router-id x.x.x.x config area edit 0.0.0.0  next end config network edit 1  set prefix 192.168.2.0/255.255.255.0  next end

Why do we need to   add the port parts also like below 

config ospf-interface  edit "internal  set interface "port1"  set priority 200  next  end end

In cisco  we need only parts to broadcast a network using ospf 

router ospf 1  network 192.168.2.0 0.0.0.255 area 0 

in the below picture no interface is configured 

Thanks

[emnoc]

This is not a cisco and you missed the earlier part, port specific ( ospf cmds )  goes under  interfaces. Follow the fortiOS guide and advance routing for examples.

Ken Felix

[sims]

Hi 

I agree that we have to add interface also , it's not like cisco . But I have seen couple of implementation without adding interface , they just broadcast the network .

Your advise ? 

Thanks