edit Local-in-policy

[Foxx]

On my FG100G I have created a local-in-policy with the command:

config firewall local-in-policy

edit 1

Then I have entered just 'set' and hit enter to see a list of all commands but it did not show any command list.

I entered 'show' and it shows the uuid.

I configured the local-in-policy and when I enter show it shows the policy settings and the uuid.

Do I have to remove the uuid or is this something I don't have to worry about?

May thanks in advance 

[Toshi_Esumi · Accepted solution]

Don't touch it and leave them alone.

https://docs.fortinet.com/document/fortigate/6.0.0/handbook/79854/uuid-support

Toshi

[Toshi_Esumi · Accepted solution]

Don't touch it and leave them alone.

https://docs.fortinet.com/document/fortigate/6.0.0/handbook/79854/uuid-support

Toshi

[Foxx]

Thank you very much. Have a good one :)

[Yurisk · Accepted solution]

Additionally, you cannot really delete this even if you try to:

FGT-7-2-0 (0) # show
config firewall local-in-policy
    edit 1
        set uuid 697eaaae-bb29-51ec-dd0e-e7b552859385
    next
end

FGT-7-2-0 (0) # unset uuid 
UUID attribute cannot be unset directly.
Command fail. Return code -37

[Foxx]

Thanks Yuri :)

[marypoppins]

Hello,

"Then I have entered just 'set' and hit enter to see a list of all commands but it did not show any command list."

After typing 'set' command,  don't you should type a question mark to see available possibilities (and not enter again)

[Foxx]

Also this issue has been resolved and it turned out the FG50E is faulty and has been replaced.