Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
dynamic IP Pool for VLAN interface
Hi,
I have a problem with assigning a Dynamic IP Pool to a VLAN interface (to access internet)
On physical interface is working, but not on the VLAN.
I just upgraded to a FortiGate 501E with 6.0.4 from a 800C with 5.6.3. On the old Fortigate is working just fine
I attached both policies and networks (I use a 10Gb interface for multiple VLANS I have)
Thanks!
Labels:
- Labels:
-
6.0
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
do you have a range of addresses that uses a dynamic pool routed from ASR to FGT?
Jirka
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nor sure if I understood correctly your question.
I have a /24 routed from ASR.
And with the old fortigate is working just fine, with same rules.
Thanks
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is the only difference between models and FortiOS?
Is it possible to reach each vlan interface IP of FW.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I foud the problem.
After I cleared the ARP cache on Cisco ASR it started to work
Thank you!
