- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
diagnose debug application sessionsync level
anyone with experience on the diagnose debug for sessionsync (FGSP)?
i tried the -1 on 7.2.8 and think I once saw the sync packets on the output, but at the moment I don't see anything when the system is working normally and session sync is working. when i run a resync all command with diagnose test application sessionsync 9 I do get some output, but not during normal operations.
another debug level perhaps? i did try a few, but couldn't get any other output to show.
- Labels:
-
FortiGate
-
High Availability
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @boneyard ,
Have you tried the below debugs?
diag debug enable
diag debug console timestamp enable
diag debug application hasync -1
diag debug application hatalk -1
Also, check when was the last time hasync happened using the command "get system ha status"
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thanks will give that a try, but isnt that more for FGCP then FGSP?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @boneyard , Sorry my bad. The commands I shared are for FGCP.
Are you seeing the sync session counts incrementing on the get system ha status output?
https://community.fortinet.com/t5/FortiGate/Technical-Tip-FGSP-Configuration-Guide-for-Session-Sync-...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
no as this is FGSP cluster between two standalone firewalls.
it is working, but I am wondering about the lack of debug output for the
diagnose debug application sessionsync -1
command, is that expected.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, yes debug for the FGSP is diagnose debug application sessionsync -1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yeah, im aware of that, the question is what I can expect. with it enabled im not seeing any output when FGSP is sending session sync packets.
Created on ‎02-15-2025 01:20 AM Edited on ‎02-16-2025 04:24 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
[edit] sorry, wrong question, haven't gotten this worked out. might take another look soon.
