default route in wan load balance state

[Saba1989]

hi everybody

i configured a 200D fortigate wan load balance,step by step i followed fortinet document

but i have a serious problem:

i configured 3 ISP links load balance and one Intranet link seprated i wrote default route and policies but 

load balance can't work and say "there is no route" however Intranet work properly  so i believe maybe i make a mistake in load balance configure

i post my configure

what is my mistake?

[Dave_Hall]

I'm pretty sure you need to define the static routes for all three "WAN" connections if they are all on static IPs. 

Edit: If you have defined static routes for all three WAN connections, check the routing monitor to see if all three default routes are up. 

[sw2090]

Hi,

I use WLLB here too on many FortiGates. I just set a default route that goes over the wllb interface (virtual-wan-link) and Clients have Policy that allows them to go to the internet via virtual-wan-link (=WLLB). This works fine so far.

maybe this helps you...