- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
cannot access FG 50E through LAN ports
LAN ports became very slow, the browser return "unresponsive page" error. the GUI can be accessed through WAN port and console normally.
LAN ports throughput is not exceeding 2Mbps!
- Labels:
-
FortiGate
Nominate a Forum Post for Knowledge Article Creation
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
- « Previous
-
- 1
- 2
- Next »
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can repair it, just heat the CPU with a hot air gun which will resolder the solders under the CPU. The problem comes from the ball solders under the CPU which degrade over time, you just have to melt them for a few seconds for the FG50E LAN ports to work again :
See more here : https://community.fortinet.com/t5/Support-Forum/Fortigate-50E-Dying-Packet-loss-and-lan-ports-stop-f...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, did you check the port speed and duplex? Are you connecting your Pc directly to LAN port? What about pinging the ip address of lan interface? Do you have huge packet loss? In this case maybe an RMA is recommended.
- « Previous
-
- 1
- 2
- Next »