can not config anti-repay in fortigate 7.4.3 vm version

[goodfortinet]

i want to config "set anti-replay strict" ,but when i show this configure,But when I checked the configuration, I couldn't find the content of my configuration. Is it due to VM licensing reasons? Or is it a problem with my configuration? If it's a configuration issue, how should I configure it

[nweckel · Accepted solution]

Hello goodfortinet,

'anti-replay strict' setting is the default setting. It will not show in 'show system global' as only non-default settings will be displayed. You can display all settings with command 'get system global'.

You can check in cli reference for default settings

[nweckel · Accepted solution]

Hello goodfortinet,

'anti-replay strict' setting is the default setting. It will not show in 'show system global' as only non-default settings will be displayed. You can display all settings with command 'get system global'.

You can check in cli reference for default settings

[goodfortinet]

thank you very much

[hbac · Accepted solution]

Hi @goodfortinet,

To see all the settings, you need to run "show full". It is also possible to use 'grep'. For example: 

show full | grep replay

Regards,

[goodfortinet]

thank you,According to your method, after testing, I can see the default "anti replay strict" sets.

[pminarik]

You already got the answer, so just a small note for future reference: A non-available command will give an explicit error when you try setting it.
Example:

[goodfortinet]

thank for your reply