- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
auxiliary-session configuration issue
When I enter the auxiliary-session command on the fortigate 50e device, it does not work.
I would like to know if the auxiliary-session command is not set on the fortigate 50e device or if it is a version issue.
Solved! Go to Solution.
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- In FortiOS 6.0 and earlier, the auxiliary session feature is not supported.
- In FortiOS 6.2.0 to 6.2.2, the auxiliary session feature is permanently enabled.
- In FortiOS 6.2.3 and later, the auxiliary session feature is disabled by default, and can be enabled if required.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the reply
My fortigate 50e version is 6.2.14.
When checking the settings, there is no set auxiliary-session command.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Do you have multiple VDOMs? If so, from which VDOM are you checking the command?
If this is not the case then I guess it may not exist on small models, because it consumes extra resources when enable (this is just a supposition that need to be checked).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
My device does not have multiple vdom set up
During initial setup of fortigate 50e device
config system setting -> set auxiliary-session enable/disable
The command is not visible.
(I have a 60F device, so the command is confirmed when setting 60F on the same OS.)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @sunnew,
Looks like that command is removed and only works on hardware with NPU (higher models only).
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you for your answer.
Is there a way to check if my device has a hardware npu?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Datasheet says no NPU.
https://www.fortinet.com/content/dam/fortinet/assets/data-sheets/FortiGate_FortiWiFi_50E_Series.pdf
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I understand.
Thank you for answer
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey Sunnew,
Thank you for contacting the Fortinet support, you can refer the below document:
Can you please provide the below command output.
#get system status
BR,
Piyush
