- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
auto save
Hi ,
how to verify that auto save is enabled
code 5.2.x
When I click revision ,I can see " you have unsaved changes ,save now "
What does it mean ,How can I see pending configuration to be saved
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If your fgt has config revision diff you can always check/compare that. If you are not sure, it doesn't (shouldn't) hurt to resave "changes" again then compare. Mind you if I recall correctly, the fgt tends to treat certain things you do in the GUI as a change.
If you really want to automatically save changes, I suggest looking at cfg-save under config system global.
NSE4/FMG-VM64/FortiAnalyzer-VM/6.0 (FWF30E/FW92D/FGT200D/FGT101E/FGT81E)/ FAP220B/221C
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If your fgt has config revision diff you can always check/compare that. If you are not sure, it doesn't (shouldn't) hurt to resave "changes" again then compare. Mind you if I recall correctly, the fgt tends to treat certain things you do in the GUI as a change.
If you really want to automatically save changes, I suggest looking at cfg-save under config system global.
NSE4/FMG-VM64/FortiAnalyzer-VM/6.0 (FWF30E/FW92D/FGT200D/FGT101E/FGT81E)/ FAP220B/221C
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have not find any difference checker , where i can find this .
And there is no cfg-save under config global
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Click on your login ID and choose Configuration then Revisions. From there highlight two config files and choose Diff. If need be, choose Save a config.
The fgt does not show any config settings that set to defaults. In this case, cfg-save (under config system global) may be set to automatic. You can see this if you type show all.
NSE4/FMG-VM64/FortiAnalyzer-VM/6.0 (FWF30E/FW92D/FGT200D/FGT101E/FGT81E)/ FAP220B/221C
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am using the version 5.2.1
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think you can compare the output of commands to show configuration detail and debug cfgmgr show configuration file primary. The show configuration detail has the configuration with new changes which are not saved.