allow management access to physical wan ports

[560832]

Management access | FortiGate / FortiOS 7.0.0 | Fortinet Document Library

"Management access to the FortiGate will be limited to a single physical interface."

Foritgate 80E, has 2 WAN ports, but it is really not possible to access management GUI both public IP address on WAN1 and WAN2.

So far, I can access management GUI on WAN1 public IP address only.

[dingjerry_FTNT · Accepted solution]

Hi @560832 ,

Could you please show your WAN2 interface settings and the routing table on FGT?

# get router info routing-table all

It's better to provide the FGT config if you don't mind.

[560832]

# get router info routing-table all

From this command, I noticed the higher AD distance was not on the routing-table.

I set the same AD distance on both static routes, then I got the access to management page.

[AEK]

Don't do that. It is totally insecure.

[560832]

Yeah even if i do i will mask publc IP address.

[560832]

I would like to know if it is possible to allow management access to 2 physical wan port.

It should be possible but I could not find any official document so far.