Wifi Bridge Slow 5.2.1

[Nihas]

Hi I am using 200D 5.2.1 and FAP221 B 5.2.1. It seems if there are more request to process , FAP' s are dropping the packets and the latency to the gateway is very high. ( From a wireless client machine to gateway) Normally it should be below 10ms to the gateway. But whenever I face the issue, that time the latency to the gateway is around " 2000 ms " I had FAP restart issues with 5.2.0, bud didn' t have this performance issue. But in this latest version, I haven' t faced any restart issue since the upgrade, but unfortunately encountered the performance issues. :( There is not much clients are connected to the FAP, only 10-15 clients..!! Any similar experience? Best Nihas

[Fatih]

Hi, have been used to examine the profile required. but you can use the following command. config wireless-controller wtp-profile edit " profile" set ip-fragment-preventing tcp-mss-adjust icmp-unreachable end

[pcraponi]

It' s a broadcast issue.. As a bridge, you are with Wifi and Cable users on the same VLAN, right? Try to put your wireless users on a isolated VLAN. The broadcast packets of all networks are come in Wireless and increasing your wifi queue... Regards, Paulo Raponi

[Nihas]

Hi, Thanks for the reply. Yea. I am using bridged network. Basically, I have restricted the streaming /downloading and most bandwidth occupying applications through UTM in office hours with an exception for 1 hour (lunchtime). And they can do streaming downloading etc during this leisure period. I am experiencing the issue only during this peak period. or sometimes when there is a high network utilization. And i have never experienced such performance issue in the previous versions even though they had some other issues ( reboot). As you suggested I will create one Tunnel mode with a different broadcast domain and will see how it works. @Faith, Thanks , Can you please bit explain what this command does to improve the performance.