What is the command in CLI to refresh web filter features

[Aaron_Abrincia_Meimb]

Hi Engineers, What is the command in CLI to refresh the web filter features? Because I' m experiencing that after configuring webfilter on the CLI It didn' t display on Graphical User Interface. Regards Aaron

[Dave_Hall]

@Aaron Abrincia Meimban What you have listed in your screenshot is the urlfilter section of your config -- not the actual webfilter profile. As far as I am aware, under 5.0.x there doesn' t seem to be a way in the GUI to select (as in a pull-down list like in 4.0 MR3) the URL filter list for your Webfilter profile. You may need to manual edit the web filter profile to include the correct urlfilter list, which I am assume is what you were aiming for.

[Aaron_Abrincia_Meimb]

HI Engineers, Thank you very much for all the efforts. My last question for you is that how to display the whole configuration without seeing this display " --More--"

[Dave_Hall]

I don' t think you want to do that, especially if your config may be >600 lines. But the setting is listed under config system console. you' re better off saving an uncrypted back up config and loading that into a text editor.

[ede_pfau]

Use this command to switch off the ' more' option:

 conf sys cons
    set out st
 end