Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
Bretfred
New Contributor

Vlan Interfaces Showing under wrong port in zone

Basically what the title says. Vlans are set to a certain port but show up under a different port under the zone i have configured. I took some out of the zone and put them back in it fixed some but others I cant fix. Even if i delete the vlan and recreate it and add it back to the zone. Not a huge deal as everything is working fine its been like this for a while over several versions running 6.2 now. Any ideas?

3 REPLIES 3
hubertzw
Contributor III

Can you share your config? I mean the interface part.

Bretfred
New Contributor

Here it is https://pastebin.com/rrw8xexB

Also to add to this if you look at the zone config the two at the end of zone lan belong to port 34 but show up as being connected to port 36 at the bottom instead of 34 which you see at the top with the rest of the wifi vlans https://imgur.com/a/cOVKRf4. If you add them all at the same time they are fine but if you add anything later without deleting the all of the ones that belong to the same port and readding them it misplaces them.

hubertzw

Can you enable " set vlanforward enable" on port34?

 

Can you show from the GUI: - zone "lan" - port34?

 

 

 edit "port34"
        set vdom "root"
        set type physical
        set description "Aruba-3810M"
        set alias "Aruba-3810M"
        set snmp-index 34
        set speed 10000full
    next
    edit "port36"
        set vdom "root"
        set allowaccess snmp
        set vlanforward enable
        set type physical
        set description "CHS-Admin"
        set alias "CHS-Admin"
        set snmp-index 36
        set speed 10000full
    next
edit "CHS-101"
        set vdom "root"
        set ip 10.101.0.1 255.255.252.0
        set allowaccess ping snmp
        set device-identification enable
        set role lan
        set snmp-index 91
        set interface "port36"
        set vlanid 101
next
edit "CHS-APs"
        set vdom "root"
        set role lan
        set snmp-index 92
        set interface "port36"
        set vlanid 1000
next
edit "RuthWifi-209"
        set vdom "root"
        set dhcp-relay-service enable
        set ip 10.209.0.1 255.255.255.0
        set device-identification enable
        set role lan
        set snmp-index 96
        set dhcp-relay-ip "10.10.10.4" "10.10.10.245"
        set interface "port34"
        set vlanid 209

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors