Virtual IP to multiple internal IP

[bigneo7]

Hello,

I would like to setup configuration using one virtual IP to connect multiple internal IP/host. How can I do the setup?

Model: FortiWeb 1000e with firmware 6.3.1-build1056

Thank You

[jintrah_FTNT]

Hi,

 Are you trying to host multiple domains on a virtual IP, and that you needed to redirect the traffic to multiple internal hosts based on domain? Could you please detail the proposed setup?

Best regards,

Jin

[bigneo7]

Yes, I would like to redirect the traffic to multiple internal hosts based on domain

WAN -> VIP -> multiple internal hosts based on domain

VIP: 192.168.10.90

Internal host: 192.168.10.91 (abc1.com) & 192.168.10.92 (abc2.com)

user from wan access to abc1.com , VIP will redirect to 192.168.10.91

user access to abc2.com , VIP will redirect to 192.168.10.92

using same VIP

[jintrah_FTNT · Accepted solution]

Hi,

Ok, that is achieved using http content routing. When you create server policy, choose the deployment mode as http content routing, please see FortiWeb 5.8.3 Administration Guide - Defining your web servers (fortinet.com)

Best regards,

Jin

[bigneo7]

Noted. Thanks @jintrah_FTNT 

One more thing, the management interface subnet cannot same with interface port 1? tried to configure both port with same subnet but there is an error

[jintrah_FTNT]

Yes, that is right, we cannot have an interface in the same subnet as defined on another one.

best regards,

Jin

[bigneo7]

May I get an explanation why cannot have same an interface in the same subnet as defined on another one?

[jintrah_FTNT]

Please refer the device administration guides on what configurations are possible and supported.

https://help.fortinet.com/fweb/554/Content/FortiWeb/fortiweb-admin/network_settings.htm states "Two network interfaces cannot have IP addresses on the same subnet."

best regards,

Jin