Virtual IP doesn't show up in list

[piacas]

Running v5.6.2, created a VIP under DNAT & Virtual IP's with a port forward.

Create a new policy and when select destination, the VIP isn't listed, only addresses. I made for interface setting in VIP and poicy are the same for incoming. Anyone seen this? I've made VIP's in 5.4/5.2 the same way and worked fine....

Thx

Dave

[Toshi_Esumi]

I quickly tested 5.6.2 w/ FWF60D but as long as the interface is matching (I used wan2), the port-mapping I configured shows up in the "Select Entries" on the right side of the GUI screen.

[piacas]

And thats what I've seen before on other units. this is a demo 100D and it doesn't show up. I tries with matching interfaces, using 'any', just doesn't show up....

[Toshi_Esumi]

I'm almost sure it would still work if you configure it via CLI.

[piacas]

Even thru CLI the VIP name isn't listed.

[piacas]

So even after adding a new one with the '+' option when making the policy for dstaddr, it still doesn't show up. Shows up in the VIP's now....but not for a selection to select for dstaddr......

[piacas]

Central NAT was enabled. As soon as disabled it, it was available. How would one does this if central NAT was enabled?

[brycemd]

I'm not exactly sure what the problem is, but I can tell you it shouldn't have anything to do with Central SNAT. My VIPs show up either way, since VIPs they are DNAT.

[chrismes]

Same here, FG-60E v5.6.2, did not see VirtualIP in list (GUI). After disabling Central NAT VirtualIP was shown in list and could be used in policy.

[chrismes]

Same here on FG-60E v5.6.2. After disabling central NAT, virtualIP was shown in list.