VPN SSL double stack IPV4 and IPV6

[Meni]

Hi i have a problem to ativate double stack for  vpn ssl

config vpn ssl settings
    set dual-stack-mode enable
end

Response in cli mode

set dual-stack-mode enable
To enable dual-stack-mode, all SSL-VPN policies must be configured with IPv4 and IPv6.
node_check_object fail! for dual-stack-mode enable 

I have only one vpn policie. do you have an idea ?

Regards

[Meni · Accepted solution]

where do you pu this argument ?

[dbu]

Hi @Meni ,
Have you included IPv4 and IPv6 on the SSL VPN policy?

Have a look at the guide here:
https://docs.fortinet.com/document/fortigate/7.0.0/new-features/766455/dual-stack-ipv4-and-ipv6-supp...

[Meni]

Hi @dbu 

Thanks for your response

I changed my policy. Before i have a policy for v4 and one for v6. I put all V4 and V6 and the same.

Now the dual stack is ok but when i connect vpn i only have v6 address and ip V4 is not forwarding

Regards

[dbu]

What do you mean ?
Do you have an IPv4 stack configured on your client ?

Check with ipconfig /all .

If yes, try to ping
execute ping www.bing.com

You can use this command and check if you see any traffic:
diagnose sniffer packet any icmp 4

[Meni]

find the problem but not the solution

When i make connection, i don't have ipv4 adresse distributed by fortigtate

Adresse IPv6. . . . . . . . . . . . . .: fdff:ffff::2(préféré)
Adresse d’autoconfiguration IPv4 . . . : 169.254.196.34(tentative)

[Meni]

I made some test. Its very strange

When i made connection to vpn SSL with IPV6 address i can access only on ipv6 devices

When i made connection to vpn SSL with IPV4 address i can access only on ipv4 devices

Really strange 

[dbu]

I have not tested this myself, but i think dual stack means that client can use either IPv4 or IPv6 to connect to the destination address. 
In your case when you connect with IPv6 you can reach only IPv6 destinations available . 
So you choose which stack to use.  You will get an IPv6 assigned and not an IPv4. 

[Meni]

I have the impression but it's still not very friendly
It will be difficult to choose the V4 or v6 connection depending on the servers to reach

Thansk for your help

I'm still looking

[dbu]

If you are using the web mode, users can access both IPv4 and IPv6 bookmarks in the portal.
The attribute, prefer-ipv6-dns can be enabled to prefer querying IPv6 DNS first, or disabled to prefer querying IPv4.

[Meni · Accepted solution]

where do you pu this argument ?