Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
JoeBucar
New Contributor

VPN Phase 1 issue

Hello,

We are trying to replace a 60B with a 60D.  It appears that I am having a VPN issue.  I have several VPN's and 6 of 8 are working.  The most important VPN is not working.  When I test the VPN it fails and the error in the fortigate log is PHase 1.  I then did some reading on the CLI to execute debug and read that log and I expected to see a pre-shared key mismatch but I did not get one. Enclosed is the CLI log.  It talks about a PAYLOAD-MALFORMED message. I could use some help.

 

Thanks,

Joe

3 REPLIES 3
Shawn_W
Contributor

bump

Christopher_McMullan

From the debug:

ike 0:WAN2-UHCCAREA-Tunnel: created connection: 0x2492600 6 440.87.22.144->330.9.144.10:500.

 

Did you hide the first octet, or is the output as received?

 

440.x.x.x and 330.x.x.x are not valid IPs.

Regards, Chris McMullan Fortinet Ottawa

JoeBucar

Hello,

I did change the IP addresses in the attachment.  I called support and he took the config file from the 60b and copied and pasted the pre-shared key into the 60d and the tunnel came up.  I then contacted the client again and the PSK we had on record was not the same that they had.  So the lesson is verify your PSK.

 

Thank You,

 

Joe 

 

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors