Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
malakibrahim
New Contributor

VPN Manager - hub behind NAT device

Hello 

I have a hub and spoke topology created via VPN manager on FMG, the Hub is behind a NAT device (hub is configured with a private IP address), where can I configure the public IP address of the hub? if the ISP is connected via two ISP can I configure two public IP addresses instead of only one? 

 
1 REPLY 1
sw2090
SuperUser
SuperUser

a vpn tunnel (hub aswell as spoke) is always tied to an interface.

So tie it to the WAN interface you want to use.

The interface ip wil be the ip the tunnel uses as source ip.

 

There is also some way to use sd-wan but I never tried to.

-- 

"It is a mistake to think you can solve any major problems just with potatoes." - Douglas Adams

-- "It is a mistake to think you can solve any major problems just with potatoes." - Douglas Adams
Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors