Upload .conf file via serial (console)

Zyndarius · ‎10-11-2011

Greetings community. I have a doubt about the following topic: Is there any way to upload a backup configuration file via serial (console) to the fortigate unit?. Thanks in advance for any possible feedback.

Carl_Wallmark · ‎10-11-2011

Hi, Dont think so, these are the option via the CLI: LTFW01 (global) # execute restore config ? ftp load config file from ftp server management-station management-station tftp load config file from tftp server to firewall usb load config file from usb disk to firewall` however you could prep a USB memory stick, and perform a restore via the conosle

FCNSA, FCNSP
---
FortiGate 200A/B, 224B, 110C, 100A/D, 80C/CM/Voice, 60B/C/CX/D, 50B, 40C, 30B
FortiAnalyzer 100B, 100C
FortiMail 100,100C
FortiManager VM
FortiAuthenticator VM
FortiToken
FortiAP 220B/221B, 11C

FortiRack_Eric · ‎10-12-2011

Hi you can' t upload the config via console like with x-modem protocol. If you format the flash disk in the boot sequence you must use TFTP to load the firmware. Cheers Eric

Rackmount your Fortinet --> http://www.rackmount.it/fortirack

Zyndarius · ‎10-14-2011

Alright, I see. Thanks for the advice.

ddskier · ‎10-27-2011

I believe you can also restore the config file from a USB key as well.

-DDSkier FCNSA, FCNSP FortiGate 400D, (2) 200D, (12) 100D, (2) 60D

FortiRack_Eric · ‎10-27-2011

An USB key cannot be mounted in pre-boot only on a running machine

Rackmount your Fortinet --> http://www.rackmount.it/fortirack

ddskier · ‎10-28-2011

Yep. Good point. I didn' t see the question was for the pre-boot config load. TFTP is the only option then.

-DDSkier FCNSA, FCNSP FortiGate 400D, (2) 200D, (12) 100D, (2) 60D

Upload .conf file via serial (console)

Nominate a Forum Post for Knowledge Article Creation